Has an IP address, but not connecting to the Sentry Base (flashing light).
The printer light is solid
The SRVR light will flicker at first, but then will never come back on
The SR25.zip thumb drive shows no logs. The thumb drive is unlocked, so it can be written to. It was almost like it never read the file.
Last update: KB3087985 (Everything worked after this was installed.)
Blueprint Admin: 5.1.8321
Sentry Base: 22.214.171.12420
Services: All running
Restart did not correct issue
Switch Ports: Allow for multiple MACs
There is no firewall between the printer and server
Printer in correct VLAN
I have been able to reset the SR25 to factory defaults and have been able to access the web page. When I tried to complete the configuration from there I ended up in the place. The only difference of course is that I was able to see the following error message: Configuration was successful. BASE server is 'j2k8-3.vmdomain.local:9072'. SR25 is now rebooting and this service is disabled.
Then the status is the same as before with the Network flashing, the printer light solid, and the server off. I know that the "j2k8-3" server is from Pharos. But, why wouldn't it pick up the config from my SR25.zip file?