These are the release notes for version 2.6.5
After upgrading my installation my device would not make a connection to the server.
I had to add a Managed Handler for the *.svc
I don't know if it was basic IIS install(Server 2012R2) or some other error.
After adding the Handler manually it worked correctly.
Can you please compare the IIS setup with the one outlined for Win server 2k12 in the Installation and Configuration guide?I do recall on Server 2k12 I saw the service not activating properly with the default IIS configuration. I enabled HTTP activation as shown in the doc and it worked fine. I didn't have to add any handlers manually, but maybe your solution is just a different approach of solving the same problem.
We had originally did the install on 2.5.1 and did not have this option in the Install manual and we therefore added the handler manually.
When we upgraded to 2.6.3 we did not go through the install guide properly again(Naughty naughty) and did not do the HTTP Activation.
I have now done it on my server, I had to reinstall the iMFP 2.6.3 and now it all works properly.
Thanks for your help
Bruce Mcphee | System Analyst | Xerox Software Support
Direct: +27 11 9289111 | Cell: +27 82 8955020
Email: Bruce.Mcphee@bdsol.co.za<mailto:Bruce.Mcphee@bdsol.co.za> | Web: www.bytesdocumentsolutions.co.za<http://www.bytesdocumentsolutions.co.za/>
Bytes Document Solutions
A member of the Altron Group. E-Mail Disclaimer: www.Altron.com/Email.asp<http://www.altron.com/email.asp> or Phone: +27 (0)11 645-3600
Our BBBEE rating as a Level Two Contributor allows our customers to claim 125% of their spend towards their
preferential procurement measurement for their own BBBEE status.
Retrieving data ...